iSCSI Appliance model range

A Flexible, Scalable, and Cost-Effective Storage Area Network (SAN) System Designed for Easy Deployment and Future Growth.

Internet Protocol (IP) SAN systems, such as the iSCSI IP storage 2u12, use the emerging iSCSI standard for data transport over existing Ethernet infrastructures. With industry-standard hardware architectures and simple new SAN management tools to further lower the cost of SAN systems, IP SANs are now within reach of most companies. Featuring a single Intel® Xeon® processor, support for up to 12 Serial ATA (SATA 300) hard drives, iSCSI or optional Fibre Channel connectivity and intuitive SAN management tools, the iSCSI IP storage 2u12 provides easy management of storage resources. It also has the built-in headroom to accommodate an IT administrator's rapidly growing storage needs. iSCSI IP storage 2u12
Hardware Specifications
Models:

iSCSI IP Storage 2u12/3000
iSCSI IP Storage 2u12/4800
iSCSI IP Storage 2u12/6000

Raw Storage Capacity Expandable to 3.0 TB - using twelve 250 GB drives
Expandable to 4.8 TB - using twelve 400 GB drives
Expandable to 6.0 TB - using twelve 500 GB drives
Drive Bays 12 Serial ATA (SATA) Hot Pluggable
Hard Disk Drive Supported 3.5" SATA
Processor A single Intel® Xeon® processor 2.80 GHz with 1 MB L2 cache
Memory Capacity 2GB expandable to 16GB maximum
Memory Type Synchronous Dynamic Random Access Memory (SDRAM), DDR2-400, Registered, ECC
DIMM Slots Six 184-pin DIMM sockets
Enclosure Management Controller On-board Vitesse* VSC055 micro-controller
Temperature Sensor Two temperature sensors are located on the backplane that allows drive cage temperature monitoring by enclosure management
SAF-TE Support The backplane firmware complies with version 1.00 rev 041497, of the SAF-TE specification
SATA Compliance SATA 1.5 Gb/s, 3.0 Gb/s
Client Connectivity Client connectivity via Internet Protocol Small Computer System Interface (iSCSI) Dual Gb/s Ethernet Quad Gigabit Optional
Serial Port Management console port
Front Panel
LEDs Fault, ID, Power
Back Panel
Buttons and Switches Power button, Reset button
I/O Connectors 1x RJ-45 COM B Serial port, 2x RJ-45 Ethernet ports
Power Receptacle 1x IEC AC per installed power supply module
Chassis
Form Factor 2U rack-mount chassis
Height 86.7 mm, 3.41"
Width 447 mm, 17.6"
Depth 631 mm, 24.8"
Color Black plastics, Silver sheet metal
Rack Support As shipped (zero drives): approximately 16 kg, 35.2 pounds
Fully configured (twelve drives): approximately 27.5 kg, 61 pounds
Shipping container: 3.2 kg, 7 pounds
System Cooling
Fans Chassis includes three dual rotors and two single rotor 40 mm hot-swappable redundant system fans for cooling the hard drives, baseboard and SATA Host Bus Adapter (HBA) cards

The Power supply enclosure contains one 60 mm fan
Power
Configuration 500 W continuous, 1+1 redundant power supplies
Max AC input current (PS Module) 7.2 Amperes at 110 Vrms, 3.5 A at 220 Vrms (each power supply module)
Max +3.3 V output (PS Enclosure) 20.0 A (total combined power for the +3.3 V and +5 V outputs should not exceed 120 W)
Max +5 V output (PS Enclosure) 20.0 A (total combined power for the +3.3 V and +5 V outputs should not exceed 120 W)
Max +12 V output1 current (PS Module) 18.0 A (total combined power for the +12 V outputs should not exceed 360 W)
Max +12 V output2 current (PS Module) 18.0 A (total combined power for the +12 V outputs should not exceed 360 W)
Max +12 V output3 current (PS Module) 18.0 A (total combined power for the +12 V outputs should not exceed 360 W)
Max -12 V output current (PS Module) 0.5 A (each power supply module)
Environment
Ambient Temperature Operating (system): 10° C to +35° C, with maximum change not to exceed 10° C; non-operating (system): -40° C to +70° C
Relative Humidity Non-operating: 90% @ 35° C non-condensing
Acoustics <59 decibel average (dBA) (rack mount) in an idle state in a normal office environment (23° C)
Electrostatic Discharge 15 KV per Intel test specification
Safety Compliance
Argentina IRAM
Canada UL60950 – CSA 60950 (UL and cUL)
Europe, CE Mark EN60950 (complies with 73/23/EEC)
Germany GS License
International IEC60950 (CB Report and Certificate)
Nordic Countries EMKO–TSE (74-SEC) 207/94
Russia GOST 50377-92
United States UL – 60950 – CSA 60950 (UL and cUL)
China GB4943 – CNCA Certification
Australia/New Zealand AS/NZS 3548 (based on CISPR 22)
Electromagnetic Capability (Class A) (EMC)
Canada ICES-003
Europe, CE Mark EN55022; EN55024 & EN61000-3-2;-3-3 (complies with 89/336/EEC)
International CISPR 22
Japan VCCI
Korea RRL, MIC 1997-41 and 1997-42
Russia GOST 29216-91 and 50628-95
Taiwan CNS13438
United States FCC, Part 15
China GB 9254 - CNCA Certification
GB 17625 - (Harmonics) CNCA Certification

 

iSCSI Appliance Ltd

Send mail to Webmaster with questions or comments about this web site.
Copyright © 2006 iSCSI Appliance Ltd. Tel: +44(0)8704 286186
Last modified: January 2006.  All trademarks are acknowledged and owned by their respective owners.

The information contained within this document may not be reproduced or distributed without the written permission of the author and iSCSI Appliance Ltd ©2005/6.